Showing all 18 resultsSorted by popularity
-
$18.003 inch bar end consists of 2" DOM .25 wall 2.5" long, two polyurethane bushings, and one 3" long inner sleeve accepting a 9/16 bolt.Add to cart -
$125.00-6061 aluminum -9/16'' hole -Works on any bar end width with a 1 1/2'' ID -Sold in sets of 16 (enough for a 4 link)Add to cart -
-
$255.00Add to cart- Single Adjustable (Rebound Adjustment)
- 6.65" Stroke
- 12.15" Compressed
- 16.0" Ride Height
- 18.8" Extended
- Eyelet / Eyelet
-
-
$365.00Add to cart- Replaces factory inner/outer tie rods with adjuster.
- One inch narrow than stock
- 3/4" Chromoly Heims RH/LH
- High Misalignment spacers
- Bolts/nuts included
- Must drill spindles and drag link to 5/8" hole
-
$70.00Adapts to factory inner tie rod and accepts 3/4" LH heim.Select options This product has multiple variants. The options may be chosen on the product page -
-
$5.009/16-18 x 4.50" Grade 8 Bolt Comes with bolt, 2 flat washers, and locking nut. We use these bolts on a lot of our kits and chassis for our 4-Link Kits, Control Arms, etc.Add to cart -
$485.00 – $535.00Select options This product has multiple variants. The options may be chosen on the product page- Convert a Ball set included (2" & 2 5/16" ball)
- Clear Anodized Finish
- This hitch is rated to tow a 12,000 lb load.
- 2,000 lb tongue weight
-
$275.00This kit is setup to run 88-98 Chevy 1500 upper/lower balljoints. We setup most of our front suspensions using the 88-98 balljoints. Includes: 2 - Upper Ball Joint Plates 2 - Lower Ball Joint Cups 4 - Upper Control arm Bar Ends and Bushings w/ Inner Sleeves (2" overall width, sleeves use 9/16" bolt) 4 - Lower Control arm Bar Ends and Bushings w/ Inner Sleeves (3" overall width, sleeves use 9/16" bolt)Add to cart -
$15.00-6061 aluminum -9/16'' hole -Works on any bar end width with a 1 1/2'' ID -Comes in a pair of (2) Mock Bushings.Add to cart
-
$365.00Add to cart
- Replaces factory inner/outer tie rods with adjuster.
- One inch narrow than stock
- 3/4" Chromoly Heims RH/LH
- High Misalignment spacers
- Bolts/nuts included
- Must drill spindles and drag link to 5/8" hole
-
-
-
